Knipex Pipe Cutter - for Composite Pipes & Protective Tubes 25mm Blade Length

Note: eBay's compatibility table is not accurate in some cases. Please refer to the following information we have provided for you.

Copyright © 2014 - 2023 Superspares. All rights reserved.

Contents : Knipex Pipe Cutter

• For cutting composite pipes Ø12.0 to 25.0 mm and for cutting flexible protective tubes Ø 18.0 - 35.0 mm without damaging a potential pipe inside
• A calibration arbor can be fitted, for example for Geberit composite pipes with Ø 11.5 and 15.0 mm
• Blades: special tool steel, oil-hardened, interchangeable
• Tool body: high-grade chrome vanadium electric steel, oil-hardened

• Pliers : galvanized
• Handles : with multi-component grips
• Weight : 332 g
• Dimensions : 210 x 70 x 20 mm
• REACH compliant : contains SVHC
• RoHS compliant : not applicable
• Cutting capacities composite pipes (diameter) : Ø 12 - 25 mm
• Blade length : 25 mm
• Cutting capacities protective tubes (diameter) : Ø 18 - 35 mm

Patented blade guidance - surprisingly simple and efficient

Front cutting area for protective pipes

The patented cutting mechanism operates with two guide plates. During cutting, these vertical plates run in the troughs of the protective pipes. Only the raised part of the protective pipes, the crest, is cut. With this system of cutting, the blade always remains at a distance to the inset pipe, so that protective pipes can be cut to size after they have been installed. A rotating movement at right angles to the protective pipe is used when cutting.

Rear cutting area near the joint for composite pipes

The composite pipes are cut in the area near the joint using a pliers action. Composite pipes are plastic pipes with aluminium insert, as used in heating engineering, for example. Technically perfect ends are vital due to the need for systems to be leak tight. When inserting the composite pipe on this Knipex pipe cutter, a jaw feeds the composite pipe at right angles to the blade; a clean cut edge without burrs is created. Because of the extremely sharp blade, the pipe end is not deformed during cutting. The section of pipe can be integrated directly with pipe couplings without any finishing work, e.g. in an underfloor heating circuit.

One single, convenient cutting tool is sufficient for all applications

Gone are the times when you had to work with several or even makeshift tools when installing composite pipes. This Knipex pipe cutter has been set in the Knipex factory as a cutting tool for composite pipes from Ø 12 to 25 mm and protective pipes from Ø 18 to 35 mm. There is an optional calibrating mandrel, e.g. for Geberit composite pipes with Ø 11.5 and 15.0 mm. The composite pipes, which are suitable for drinking water, can then be installed diffusion-resistant after cutting. Several applications - one convenient tool.